so ive got a prusa i3 and in the middle of a print every time the filament starts getting pushed out of the filament hole. any suggestions on how to fix it?

@unlimitedbacon

@unlimitedbacon said:

It would be very helpful if you could post a picture of the end of the filament.

so, i have this 3d printer https://www.walmart.com/ip/2017-Upgraded-Quality-H...

it worked fine for the first print but isnt working now, its moving correctly but not extruding, its heating up too. the ends of the filament is curled and frayed when i take it out. ive tried replacing tips, replacing tube , any advice?

Hello, would a prusa i3 diy printer be able to print nylon filament?