I found two excentric nuts loose, one under the print bed and one on the right side of the gantry. Adjusting those appears to have worked well. Thanks for the reply!

Hello! This is my first post so hopefully, it is in the right location!

Long story short my friend accidentally gave my month old ender 3 V2 a good whack right around the rollers on the right side of the gantry and problems have occurred ever since.

Part of the issue with fixing it is I have a hard time describing the problem: Each time I now level the bed(I will spend a long time making sure this is right) and then auto-home, the nozzle will scratch the bed when I turn off steppers to check if it is still level. Even if I auto-home, level the bed, and then auto home again, it will no longer be level (too high/low all over the place). I found an eccentric nut that was loose on my hotend and made sure to adjust that correctly, I tried following a guide to level my x-axis as well. I should note that before my machine was slapped I had zero issues with it.

Other than that I have no idea what to try to fix this. Any suggestions would be appreciated, thanks!