@dpc , Do you have a link to the firmware download? Also the name of the file? Thanks.
jandresen
@jandresen
Posts made by jandresen
-
RE: Updating Printer Firmware
-
RE: Inconsistent First Layer
@mpirringer , Thanks for the info. I'm printing directly through USB so it always runs the leveling with the probe. I will try flipping the build plate. Thanks again.
-
RE: Inconsistent First Layer
Hmm...Z axis rods and leadscrews aligned and X axis leveled but still inconsistent first layer. Uuuugh!
-
RE: Inconsistent First Layer
Thanks for the suggestion. So far it seems that the right screw/rod was out of alignment and that the motor was loosing steps from binding. I'm adjusting the brackets to align the rods to the screws. Hope this fixes it.
-
Inconsistent First Layer
I purchased the Pulse XE and haven't been able to get a good first layer across the entire bed. I have the BuildTak FlexPlate upgrade and am printing PLA. I have done 10x10 mesh and 100 point bed leveling with no success. I have also leveled the X axis using a leveling post to the rods. Below is an example of the inconsistent first layers:
I did receive the printer damaged and had to replace parts so I'm not sure if something is out of alignment or not.
Any suggestions? I'm using MatterControl 2.0. -
RE: Pulse profile for Simplify3D
@dlm4mh , Is the updated profile available for download anywhere?