Oh. Thanks for your input.
Posts made by ImaginationToForm
RE: [sovled] Make this curve print better?
The seam in the middle is where it is starting/ending the perimeter loops. This can't really be avoided.
Oh thanks. I was hoping there was a setting to have that start in different locations.
The rough texture could be due to a couple reasons, but it looks to me like your filament might be wet. What material is it?
Well I was more worried about that seam. But it's Inland PLA. I think there was some stringing along that curve that makes it look rough. I had only opened up this roll a few hours ago. Can get wet that fast? I was thinking about getting a food dehydrator.
RE: Warm up Extruder after startup gcode.
Hi, Thanks for response.
M104 is generated with the slicer. But I was using M109 in my start-up so wasn't being removed. I changed my code to use M104 instead and now works.
I don't know a lot of gcode but looked M104,M109 up. I've seen both in some other gcode samples;however, I don't see why both would be needed.
Warm up Extruder after startup gcode.
I really hate it when slicers make it warm up the extruder before bed leveling. This will leave little zits of filament all over bed and throw off bed leveling measurements. Please make it so we can move this to after the startup g-code.