Ive been using the robo3dr1+ for a year now. I have been getting good results. except where support material is invoved.
I have used default settings for support. I usually waste a couple printed before walking away completely frustrated..
I am at the point of giving up on matter control all together.
I have tried a few small alteration to default. but dont see any improvement.
can anyone please explain what I need to do to get the support material to be easliy removed, I am ruining prints by simply trying to remove the support.
what settings are critical for success, because apparently I am doing something wrong,
last try was on overwatch reaper from thingiverese