After the new update my supports are solid and now become part of the part that im printing, I have tried a few setting but its still printing them as solid pieces, I don't see anyone else having this issue?
Best posts made by erievon
pulse XE NylonX comparable printer
I love my Pulse XE and use it to print NylonX 24/7 for the past 3 yrs. No issues other than a thermistor on the bed that went bad. What other printers out there that can do the quality that this printer does with Nylon. I'm looking to purchase another Pulse XE but wondering if there is something out there under the $5k mark with the same quality as this printer.
RE: Help dialing in NylonX settings.
I have a Pulse XE and print at 265 hotend and 60 bed but I have a garlite bed. I print at .1 layer height, 3 perimeters and 25% infill you don't need more than that and print speeds at 30. My prints are very clean and show no layer lines. I use the NylonX to print mounts for commercial drones which hold Lidar scanners, and other high end sensors and never had one break. They have to resist vibration and breaking as some of the units being held are over 80K. Not sure how your printer would compare to the Pulse XE but I have yet to have a issue. I have been printing 24/7 for 3 years on it.
Mattercontrol layers starting in different locations
Quick question about MatterControl. Is there a way when doing circles to have is start in different areas so that there isnt material oozing out from starting in the same area. Say I do 3 walls in a circle is starts them in the same location each layer causing a gap. I know cura has a setting to not do this but do not see anything on MatterControl. Perhaps there is a gcode that im not aware of.