I have a Robo3d R1+ and this new update totally killed all my settings. Nothing imported from the previous version (filament types and settings).
Additionally like everyone else has stated the auto bed leveling feature no longer works. After probing the bed the nozzle basically sits on the glass and cannot be adjusted PERIOD! I've gone into printer/general and tried inputting Nozzle Offset to 1.6/-1.6 ..Nothing. I've gone into printer/Features/hardware and tried activating (turning on) has z prob and has Z servo.. Nothing!
The only way that I can print using MC is to run a print with a skirt and during the skirt print go into controls/movement and raise the Z height manually to 1.6 using the Z+. It has taken me days to figure this out and I only found this out through trial and error finally getting the height right.
My only other thought would be to program a G1 Z lift into the Start G-code right after probing the bed but in doing that you no longer have an accurate print because the bed is not perfectly leveled and I'm not sure if it will print with the same static number now in place.
I'm running MC version 18.104.22.16869 stable