I found other forum topics on Peopoly's site that described using lower laser power settings. I set my laser power down to 49 and got a reasonably good looking print. Still a few filled holes, but much better and the resin post cured better. Still more tweaking of the settings required I'm afraid, but progress.
Posts made by earthball
RE: Moai filled holes on ring test
Moai filled holes on ring test
Having some trouble with filled holes in my ring test print on my new Peopoly Moai. Details seem a little soft. See images below.
Room temperature is 68F (20C).
The prints have also been rather well stuck on the build plate. I did notice the alignment test showed the circle slightly smaller (~2mm diameter) than the target sheet provided when I ran through that, but wasn't aware you should do anything about it per the instructions. Not sure if that would impact this, unless parts are printing slightly under size.
Thoughts on what could be wrong?