Thank you for responding. I am using a hardened nozzle. i will print a few more, trying your suggestions one at a time.
Posts made by drift
Help dialing in NylonX settings.
I just started experimenting with NylonX, and so far it seems great, however I am having a small issue and wondered if anyone with NylonX experience could help me out. I printed a grip for use in airsoft and the main body of the grip is very solid, but there are some small lugs on the top that snapped off with very light finger pressure.
The part on the right is the NylonX grip that the lugs broke off of, the part I'm holding on the left is a PLA test piece for the lugs.
These lugs all seem like they did not stick at all, but the rest of the grip is very solid and unbreakable. These same lugs printed on the PLA piece are much stronger.
I was thinking maybe this could be due to the fact that I am not using an enclosure, do you guys agree or is it a settings problem?
Print Speed: 50
layer height: 0.2
wall thickness: 0.8
Retraction distance: 6.5
No cooling Fan
Any suggestions would be greatly appreciated.