I purchased aforementioned printer and tried to plug it in to my computer to use with Simplify3D and noticed that it was "not connected." When I checked the Device Manager the printer was registered as RAMPS and it had a Code 10 error with the driver being labeled as MatterHackers. After searching around the interwebs I downloaded the recommended CH340 drivers and tried manually updating which, to no avail, failed to work. Windows 8.1 would say that it had the best drivers installed already. I thought I had fully uninstalled MatterControl prior to plugging in the computer but I have a feeling I didn't. Should I check my registry and remove any MatterHackers/MatterControl entries, reboot, and try again or does this sound like an issue with the board on the printer?
Posts made by brianwwhitt
Maker Select Plus RAMPS