@brenthg said in Configure EEProm:

@brenthg

Do I have to do a Marlin Firmware update to make this option work?

Yep, I just updated to Marlin 2.0 and the settings are now populated in the Configure EEProm screen. Voila.

@brenthg

Do I have to do a Marlin Firmware update to make this option work?

I'm running a Geeetech A10 with the latest MattereControl software. I'm trying to adjust a few settings in the Configure EEProm. How do I get it to read my A10 to see what the default settings are. Mine shows all zeros.

Brent

@brenthg said in Home Position:

@tinken said in Home Position:

@brenthg Measure the bed manually to confirm the size and coordinates. Use these coordinates in your slicer.

I read somewhere in another forum that the print head HOME position is suppose to be offset from the bed so any residual extrusion does not pile up in the corner.

I measured the bed and the factory 220 x 220 is accurate. That still doesn't explain why my prints are not centered. I will have to discuss this with Geeetech Technical Support.

I corrected this issue by using 128,110 for the center, even though that's not actual center of the 220 x 220 bed. Not sure if that's suppose to be, but my prints are now in the center, not that it really matters.

@tinken said in Home Position:

@brenthg Measure the bed manually to confirm the size and coordinates. Use these coordinates in your slicer.

I read somewhere in another forum that the print head HOME position is suppose to be offset from the bed so any residual extrusion does not pile up in the corner.

I measured the bed and the factory 220 x 220 is accurate. That still doesn't explain why my prints are not centered. I will have to discuss this with Geeetech Technical Support.

I'm new to the 3D Printing world and I have a Geeetech A10 printer setup and printing parts. However, when I HOME the print head, it falls approx 10mm off the edge of my glass bed in X and Y. I have the bed dimensions set to what the factory recommends at 220, 220 with 110,110 as the center, but my parts don't fall in the center of the bed.

How do I correct this?