Hi all. Am new on forum and have a Lulzbot Taz machine. I am trying to print some taller models and after almost half the model is printed, the filament hardens and the model aborts. Im using the cura software. Is there a way that i can increase the temp as the project progresses? Doing it earlier on causes a lot of fine hair as expected. I am really out of ideas. Thanks in advance
Bernard
B
BernardFunguy
@BernardFunguy
0
Reputation
1
Posts
39
Profile views
0
Followers
0
Following
Posts made by BernardFunguy
-
Early abortion of pla prints