I installed MatterControl on my iMac and I could not connect to the printer.
Bill
I installed MatterControl on my iMac and I could not connect to the printer.
Bill
P.S. The port settings in Device Manager are the same as in MatterControl, so the baud rate is the same.
Bill
I'm new at this, but from their website "I3_plus_V2.1.8.hex" that's all I can find.
Bill
No, I had read a different post somewhere (sorry, I didn't save) that that was the case. The Printer connects to the PC and I see it in the Device Manager (Windows 10) and the port settings are correct, and the driver is up to date, but Mattercontrol says it can't connect. I've run out of ideas.
Bill
I am unable to get MatterControl to connect to my Wanhao Duplicator I3 Plus. I suspect that this is due to a new controller in the Plus model.
Can anyone confirm?
Thanks,
Bill