Ordered a pulse xe, not as my first printer, but my first from MH, thinking that MC and the MH support would be great.
Linux, it turns out isn’t supported by MH, information that is on the website, and after days of trying everything is information that would have likely changed my printer selection. But alas, $1200+ in, i figured it would be a great printer.
My benchy’s have very rough back and left side, while a good right side - the pics i have do have extra stringing, but that’s something i have resolved on other prints. The rough left (rear of the printer) is the part that nothing I do seems to change.
I’ve tried everything, from two computers, SD card, printing from Cura and MC, with every retraction and heat setting, and flow variants I can. I’ve checked, and found the bottom belt was very loose and the X axis had a little wiggle but nothing I could tell. I’ve tried fan full on, fan totally off, everything else imaginable. Any ideas of things to try would be helpful.
Thanks