Where is the Matter Control to randomly relocate the switch from layer to new layer instead of 'stacking' them at the same point in the print?
Posts made by BallardHill
RE: Hairs at travel to new printing point and 'nibs' randomly during print
@BallardHill My mistake - should have posted to Matter Control category
Hairs at travel to new printing point and 'nibs' randomly during print
Matter Control v1.6
Rostock MAX 2 Modified
Heated Bed surface (6mm aluminum plate); heater (silicone circular); Power Supply (24V 25A w/down regulator for 12V)
1) Getting hairs when traveling (without printing) begins;
2) Getting semi-spherical 'nibs' at undetermined locations during printing;
Any advice appreciated!