Posts made by andy4751

thanks for the reply but no its not there

hi can anyone tell me where the setting z can be negative is in matter control version 2 i can find it in the older version but not version 2

hi is there a way to save all settings in mattercontrol so i can install mattercontrol on to another computer,

as i have bought a new one and dont want to set it all up again like re doing the bed level etc

hi used matter control to auto level the bed using a piece of paper as per instructions and it is the first time i have been able to print anything,

so your program is great, but do i have to run the bed levelling every time i start the software after i have switched off the printer, excuse my ignorance

but i am new to this