Speed settings
-
Hi, can you please tell me the best speed settings. thanks.
-
@erniehatt said in Speed settings:
Hi, can you please tell me the best speed settings. thanks.
Hey there, what type of filament are you using, and how does your model look like? It depends on the combination of these two.
-
Hi thank for the reply.
I am using 1.75 PLA at the moment, but will be using ABS on some modles that require a much better heat resistance.
-
OOPs forgot to mention model quality.
Walls are OK but the flat surfaces are quite rough.
-
You should be okay at 40 - 60 mm/s, but you may want to try increasing your hotend temp by 5 to 10C.
Attach a photo of what you're getting and we can go from there.
-
Can't do much at the moment the printer is down, because of the lengthy time it takes to heat the bed, I increased the input voltage to 24c via a Mosfet unit, it increased the temp time ok, but it fails to stop at the designated temp.
Haven't a clue why, but am looking into it.