Newly connected RepRap LCD screen worked a few minutes then stopped
-
I hooked a new LCD screen to my R1 + last night with a good firmware update. I unhooked the USB, and was able to heat extruder and bed and homed the extruder. It did not show my SD card (16 gb) so I attempted to reload my file to my SD. I then found the LCD screen was frozen now and would not respond to dial changes. Not knowing what else to do I turned off my machine, and restarted only to get a plain blue screen. I uploaded the firmware again and still nothing. Any suggestions?
-
@Sybeck1 Include the U8qlib.h library in your Configuration.h file in your firmware. The first lines of the configuration.h file should look like this:
#include U8glib.h
#ifndef CONFIGURATION_H
#define CONFIGURATION_H// This configurtion file contains the basic settings.
// Advanced settings can be found in Configuration_adv.h
// BASIC SETTINGS: select your board type, temperature sensor type, axis scaling, and endstop configuration