X axis value changes after homing at the end of a print
-
After a print is finished the machine homes and show x=600 instead of 0.
If you ignore it and do another print - it just tries to print a line down the left hand side of the bed, If you disconnect and then reconnect it all goes back to where it should ie x=0 y=0 z=0 then prints fine
-
@drakkn You did not mention the printer or profile that you are using. However, you should be able to reset the values of the coordinates by placing a G90 command in the Start G-Code. The G90 command should follow the G28 homing command.
-
G28 ; Home de todos os eixos
G1 Z5 F5000 ; Move a mesa 5mm para baixo
M104 S[temperature] ; Aquece a [temperature]°C
M109 S[temperature] ; Aguarda o aquecimento
G1 E15 F100 ; Extruda 15mm para limpesa do Extrusor
G92 E0 ; Reseta o Extrusor
M206 X600 ; Rampa de Aceleração e Desaceleração
; Powered By 3DCloner DH
-
can see in that code where x600 comes from , also it is not in english
-
@drakkn Place the G90 code in a single line after the G28 line.