Pulse XE Enclosure and PrintDry System Setup
mavin last edited by
I have a Pulse XE inside the Pulse enclosure
I also have the Print Dry System
trying to figure out how to route the filament thru the supplied tube thru the side door into the enclosure
Id like to still use my BondTech Extruder
Anyone have a similiar setup or idea how to plumb?
mavin last edited by LarsBrubaker
Side door access to Extruder
tinken last edited by tinken
Set the print dry system on top of your enclosure. Then run the boden tube down into one of the holes on the side of Prusa enclosure and up to the Bondtech extruder. What kind of filament are you using?