HELP! CR-10s Pro not behaving!



  • Recently my CR 10 S Pro has been acting up. Ever since I went on a two week long vacation during December, every time I go to use the printer (about once every day or two) it is too close to the bed. I correct the Z offset, but the next time I print it is even closer to the bed. It’s gotten to the point where I have now moved the nozzle down almost half a millimeter. It is quite a pain to have to reset the Z offset every print. How can I fix this? Please help!


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.