print settings



  • The End gcode, I have in there.

    G1 Z10 :lift nozzle

    G28 : home

    M104 S0

    M84


    the problem I have with this it is ignoring the lift nozzle, it is pushing the nozzle into the finish print, what am I doing wrong.


  • Moderator

    G1 Z10 tells the printer to move to 10 mm above the bed. If your print is more than 10 mm tall, the nozzle will move down and crash into the print.

    You want the nozzle to move 10 mm higher than wherever it is at when the print finishes. In order to do this, you need to switch to relative mode using G91, then switch back to absolute mode using G90.

    G91
    G1 Z10 :lift nozzle
    G90
    G28 : home
    M104 S0
    M84
    

    You can read more about the different G-Code commands on the RepRap Wiki.



  • Thank , you very much for that, and the wiki link.


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.