Support Material Aggravation



  • One of my biggest frustrations with MatterControl is that your documentation seems to be out of date and doesn't actually match your UI and help is hard to find out on the regular internet.

    Currently, I am having problems getting support material out of a print when it is finished. Your documentation gives suggestions one of which is adjusting the Support percentage. But there is no support percentage in the UI.

    Does this setting not exist anymore? If it doesn't, please remove it from your documentation. If it does, then how do I find it because even using the settings search inside the UI isn't finding it.

    Also, how do I make these supports less dense so I can get them out of the print without messing up the surfaces?

    thanks,
    Ed


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.