Error:MINTEMP triggered



  • I have a problem with this message: Error: MINTEMP triggered.
    I noticed that for an unknown reason the temperature of the heads suddenly drops. At different times of the same print.
    ok
    N22935 G1 X35.35 Y97.33 E1204.088*84

    ok
    N22936 M105*43

    ok T:205.12 /210.00 B:89.18 /88.00 @:127 B@:0
    N22937 G1 X33.48 Y95.32 E1204.184*84

    ok
    N22938 G1 X31.78 Y93.38 E1204.274*90

    Error:MINTEMP triggered, system stopped! Heater_ID: 0
    Error:Printer halted. kill() called!
    N22939 M105*36

    N22940 M105*42

    N22941 M105*43

    N22942 M105*40

    N22943 M105*41

    N22944 M105*46

    N22945 M105*47

    N22946 M105*44
    Marlin 1.1.9 Arduino 1.8.8

    PLIS HELP!:)



  • This post is deleted!

  • MatterHackers

    It sounds like your thermistor may be going out / bad.

    Using a multimeter, set it to 100K Ohms and probe the thermistor at room temp.
    The thermistor should read ~100K +/-20 ish.

    If it is extremely high or low, you may need to replace the thermistor itself.



  • You're right, I just mentioned it and it's good 🙂 I came across this too, thank you very much 🙂


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.