Tombee67 last edited by
Been having an issue recently.
All has been OK until recently, when I started to get some strange behaviour. Printing is not a problem. However, when the print is completed and I try to print again, or print something else, the printer shuts down and all I see is "Heating failed" on the printer display. At the moment all I can do is disconnect the printer in MC, disconnect and shut down the printer, reconnect and power up again.This clears the "error" and I can continue printing.
This issue does not appear if I pause and resume a print or if I cancel a print after it's started and restart after cancel.
This happens with all filaments I use (with their relevant heat settings) i.e. PLA, ABS, HIPS.
ryan.lutz last edited by
Not sure what would be causing that, but we might be able to figure it out.
Can you post a Terminal Log, exported after a successful print and you get the error message? http://wiki.mattercontrol.com/Send_Debugging_Information#Print_Log_.2F_Terminal_Log
Please share via Dropbox, Google Drive, or similar, then post the link.