MatterControl wont connect to Anet A8.
-
Hello!
I just reset my computer because it was lagging, and now MatterControl will not connect to my Anet A8. I've tried reflashing Marlin, restarting the computer, MatterControl, and the printer multiple times but nothing seems to work. I'll link my Marlin file down below, can someone please help me so I can 3D print stuff again?
Jason
-
Try to reinstall the USB driver and then see if maybe the port number has changed. I.E from 4 to 3 or something like that and make sure the baud rate is correct
-
@mpirringer
How would I find the correct baud rate?
-
@thejasonplayz I don't have an A8 but for the printers I have it was in the manual that came with it. Most likely either 250,000 or 115,200 etc there should be a drop down with options and if you dont have the info you might have to just try. And most likely its either com3 or com4. You could set up a new printer and start experimenting with the options
-
@mpirringer
Thank you so much for the help!
I had to switch the baud rate in the printer settings and it worked perfectly!
Again, Thank you!
Jason
