Z home going to low on home. Help Needed!!
FunGi last edited by
Hello the problem I am having is that the extruder enters my print mat when set to home z. This happens every time. I have releveld the bed several times and this happens even after lowering the bed and leveling it again. Do I need to set a z offset? Printer is all stock monoprice select maker v2.
mpirringer last edited by
You could try a Z offset. But I would make sure that the Z limit switch - the one that helps it to home is ok IOW has not moved, is loose, Bent or damaged in some other way
erniehatt last edited by
That sounds about right.
But I would also try to make an adjustable end stop for the Z axis, it helps a great deal.