2 small problems



  • Hello all and sorry for my english.
    I'm trying Matter Control for some time and I'm verry happy with it. I've just had 2 small problems:

    • when changing speed multiplier in the control pan during a print, the time to print doesn't change.
    • I've cancelled a print of a part with support from bed then I rotate the part on the bed an re-run the print. Matter Control kept the old supports at the wrong place. I remove supports, re-slice, activate supports: no change. Then I changed supports from "from bed" to "normal", re-slice, change supports to "from bed" and re-slice and that was OK.

    Thanks a lot for this software.

    Dom


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.