Printing in mid air.



  • So I just recently am having an issue with my printer not lowering to the print bed from the point where it is warming up the heater which is about 25mm above the bed at the corner. The head just goes straight over and starts printing at 25mm above the bed. It seems like on some print it works just fine, then other prints it doesn’t. I have used files I made in autocad, in mattercontrol, and from Thingiverse. Think I have had problem with each.


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.