CnC Router soft ware



  • Hi I know this is not 3D printing BUT I figure some of you just might know what I don't. I have a cheap after market GRBL Router & a home brew using a RAMPS board system. & I know little about the soft ware for it I use fusion 360 for my design work and tooling set ups. I want to use the "universal G code sender to finish up please Help! Having a tough time getting it down loaded and set up please help


  • MatterHackers

    Hey @Cardman58

    I apologize for the delay here, I have been taking care of other matters here so my attention to this forum is not up to what I would normally expect it to be.

    Unfortunately, I do not have much experience in the setup of custom CNC routers. I know that some of our users here have been trying to set up custom machines as well. Where about are we stuck at in the system at the moment?



  • I use Ramps 1.4 with Fusion360 post process and MARLIN firmware not GRBL. Works great.


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.