MakerJuice G+ Black with B9 Creator 1.1, no successful prints yet!
Amblix3D last edited by
I've recently picked up a B9 creator and was printing 'okay' using a 2 year old bottle of their red resin. I then purchased MakerJuice G+ as it's recommended for the B9 from Matterhackers. My problem is, I can't get anything to stick, nor find anything on the internet about exposure settings.
I saw it was mentioned MH used to have a link with this exact information but has since been removed.
Does anyone happen to use MakerJuice G+ on their B9 with success? If so, please do share! The stock black profile is definitely a no-go...
Thanks in advance!
These are the setting we have used in the past for the MakerJuice G+.
Description: MakerJuice G+ Minimum Slice Thickness: 0.065 Maximum Slice Thickness: 0.22 Exposure Factor: 1.44291 DOC Rate Factor: 0.214218 UV Sensitivity Factor: 0.14962929 Over Cure Multiplier: 0.1 Attach Multiplier: 2.4 Attach Layers: 2 Shrinkage Multiplier: 1