Problem with Fan Speed on small prints
-
Hi all i have a problem with small print. I turn off the fan speed with small details. How to set to always be on?
My settings:
Minimum Fan Speed 100%
Maximum Fan Speed 100%
Bridging Fan speed 100%
Disable Fan Speed For The First 2 Layers
Slow Down If Layer Print Time Is Below 10 seconds
Minimum Print Speed 10 mm/s
-
Change to 'Disable Fan Speed For The First 0 Layers' should do it.
-
It does not work Fan speed is still disable
-
Setting 'Minimum Fan Speed' to 100% and 'Disable Fan For the First 0 Layers' should work, so there's either a different issue with your printer's fan, or a bug in the software.
Can you verify that MatterControl does not send the M106 command? Check the terminal output, and export to share with us, if needed. http://wiki.mattercontrol.com/Send_Debugging_Information#Print_Log_.2F_Terminal_Log
-
I discovered a bug while testing the hardware. The power cable was interrupted, but thank's for help