Wall separation on one side or area on delta
Voc007 last edited by Voc007
I have a weird wall separation on same location no matter what the print is square or circle, brim is prefect, walls are straight and even. This is happening towards at z tower side. Belts are nice and firm not to tight or loose, bed is nice,flat,stationary and level. This just started to happen, I have done 100mm extrusion test and it is within specs, like 99.8, cubes are 20.04 mm. It does not look like a separation but a cutting short on something ? I have included some screenshots and one of the brims...
It looks like it is possible that those wall separations are located on one side of the part so it is possible that there is something going on with cooling or bed level. I would say to check the cooling first and from there we may want to take a few measurements.
Do you happen to have calipers that you could use to measure out the wall thickness of the separated area and the opposite side? We may find that both walls are the same thickness or something that could point us in the right direction.