robo 3 1 plus stops printing in same spot everytime
-
Printer starts off fine, but during printing it always stops in the middle of the bed after a few layers into printing. Help needed in figuring this out.
-
Hey @humper0891
Is this stoppage always in the same spot or is it in roughly the same area? This is a very important distinction as if it is the exact same spot that would point towards the G-code but if it is a rough area then that may be hardware related in some way.
This can be solved in a few different ways but it is important to know which is happening. Do you mind dropping us a picture or two of the failed prints so I can better understand what we are looking at?
Thanks!