Not getting results when running PID calibration



  • It runs the test but errors our when ready to give me results. I'm new to 3D printing so any help would be grateful. Here is the log.

    14:47:45.327: echo: M206 X0.00 Y0.00 Z0.00
    14:47:45.327: echo:PID settings:
    14:47:45.330: echo: M301 P19.86 I1.00 D98.93
    14:49:40.149: PID Autotune start
    14:52:48.417: bias: 116 d: 116 min: 193.64 max: 208.75
    14:53:38.346: bias: 115 d: 115 min: 193.61 max: 207.23
    14:54:27.893: bias: 114 d: 114 min: 194.06 max: 206.88
    14:54:27.893: Classic PID
    14:54:27.909: PID Autotune finished! Put the last Kp, Ki and Kd constants from above into Configuration.h
    14:54:28.930: Error:checksum mismatch, Last Line: 161
    14:54:28.930: Resend: 162

    Any help is appreciated.


  • MatterHackers

    Hey @seronami

    So that error can be caused by a number of things but should overall be a non-issue as the printer was able to give you back the PID values to drop into your firmware.

    "14:47:45.330: echo: M301 P19.86 I1.00 D98.93" is the line you are looking for.



  • Those results is when I requested to see what PID’s is already in the firmware I thought. Wasn’t it suppose to post the results after the test was ran? Thank you for the reply



  • I tried 6 cycles and got a different error.

    I've tried 6 cycles this time and got this as an error.

    7: PID Autotune start 20:33:14.305: bias: 116 d: 116 min: 193.64 max: 208.32
    20:34:03.845: bias: 116 d: 116 min: 193.61 max: 206.88
    20:34:53.649: bias: 114 d: 114 min: 194.06 max: 207.11
    20:34:53.655: Classic PID
    20:35:43.076: bias: 114 d: 114 min: 193.61 max: 206.88
    20:35:43.076: Classic PID
    20:36:32.488: bias: 114 d: 114 min: 193.84 max: 206.88
    20:36:32.488: Classic PID
    20:37:21.506: bias: 114 d: 114 min: 194.03 max: 206.88
    20:37:21.506: Classic PID
    20:37:21.506: PID Autotune finished! Put the last Kp, Ki and Kd constants from above into Configuration.h
    20:37:21.538: Error:Line Number is not Last Line Number+1, Last Line: 9800
    20:37:21.538: Resend: 9801


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.