bed level query
-
hi used matter control to auto level the bed using a piece of paper as per instructions and it is the first time i have been able to print anything,
so your program is great, but do i have to run the bed levelling every time i start the software after i have switched off the printer, excuse my ignorance
but i am new to this
-
Nope, you only need to run it once. The settings will be saved and you will only need to redo the calibration if you see that something is wrong.
-
I have to run mine about once every two prints (or even one if it's a big print) - but it's because my printer sucks, not because it's a requirement of the software.