bed level query
andy4751 last edited by
hi used matter control to auto level the bed using a piece of paper as per instructions and it is the first time i have been able to print anything,
so your program is great, but do i have to run the bed levelling every time i start the software after i have switched off the printer, excuse my ignorance
but i am new to this
Nope, you only need to run it once. The settings will be saved and you will only need to redo the calibration if you see that something is wrong.
mrsatov last edited by
I have to run mine about once every two prints (or even one if it's a big print) - but it's because my printer sucks, not because it's a requirement of the software.