bed level query



  • hi used matter control to auto level the bed using a piece of paper as per instructions and it is the first time i have been able to print anything,

    so your program is great, but do i have to run the bed levelling every time i start the software after i have switched off the printer, excuse my ignorance

    but i am new to this


  • Moderator

    Nope, you only need to run it once. The settings will be saved and you will only need to redo the calibration if you see that something is wrong.



  • I have to run mine about once every two prints (or even one if it's a big print) - but it's because my printer sucks, not because it's a requirement of the software. 😉


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.