Thank you....
-
for this nice software.
The prints have an excellent quality.
especially the support structure is way better than in S3D.
I did a couple of prints with:
-support on
-support percent "Little" 10%
-create perimeter
other settings are default.
It turns out very nice, no problem with loose support like in S3D.
....very nice work, I'm so happy that I found this software.
-
Awesome. Always good to hear. Let us know if you have any issues or questions.
-
For the support material I have a question:
How can I set the maximum overhang angle?
Is it adjustable?
When I export the profile of my printer there is an varaiable that can not be found in Matter control.
-
Thanks for your great post! Glad to hear you're enjoying the software.
Overhang is calculated based on the Support Percent setting: http://wiki.mattercontrol.com/SETTINGS/General/Support_Material/Support_Options/Support_Percent
See the image in the examples section of the above linked page for a visual representation of how it works.
-
...Ok now it is clear, thank you for the information
