Soft PLA and PEI Bed - What's the Best Way to Remove Prints?
RussF last edited by
The first test print came out well, though removing it from the PEI bed was a huge pita. One of the corners of the print tore because of adhesion The temp settings I use are:
This looks like a versatile filament, or it will be once I get over this hurdle.
Any help would be greatly appreciated.
So my first question is, how close to the bed are you? It sounds more like you are adhering the filament to the plate too well. Mind dropping us a few pictures of the model on the plate if you have any.
TBH, too much adhesion is not all that common of a problem for PEI so I am intrigued by this one.