Soft PLA and PEI Bed - What's the Best Way to Remove Prints?



  • The first test print came out well, though removing it from the PEI bed was a huge pita. One of the corners of the print tore because of adhesion The temp settings I use are:
    Bed: 60C
    Extruder: 210C

    This looks like a versatile filament, or it will be once I get over this hurdle.
    Any help would be greatly appreciated.


  • Global Moderator

    Hey @RussF

    So my first question is, how close to the bed are you? It sounds more like you are adhering the filament to the plate too well. Mind dropping us a few pictures of the model on the plate if you have any.

    TBH, too much adhesion is not all that common of a problem for PEI so I am intrigued by this one.


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.