First Layer Expansion/Brim/Loops Around Support -- How To?
HesDeadJim last edited by
I'm using the latest MC version and have turned on the first layer expansion (making a brim) to help stabilize the pieces a bit better on the bed for printing. However, I've noticed that when printing support towers (for pieces that are over the 45 degree angle threshold) that this "brim" does not get printed around these structures. I would like the same adhesion to be applied to the support towers as it does for the actual printed parts. Is there a way to make that happen?
Any help would be appreciated.
ryan.lutz last edited by
Thanks for the report, Steve. This was a known issue and it has been fixed for the next version: https://github.com/MatterHackers/MatterSlice/pull/158