Jumpstart manual bed leveling



  • I have a jumpstart with a Dell Verse tablet, I have tried to level the bed with the software but still not working, can I level the bed manually and then fine tune it with the software? How do I go about leveling the bed manually

    James


  • Moderator

    There are four adjustment screws under each corner of the bed. Home the printer, then adjust the screw in that corner until the nozzle is barely touching the bed. You can use a piece of paper as a feeler gauge, the same as you would with the software leveling. Move the nozzle to each of the other corners and repeat the process.



  • Thank you very much, lot easier than I thought it would be.


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.