3rdzeropoint last edited by 3rdzeropoint
Could there be a setting added inherently into the host so that when you pause the print,
it will raise the head and move it to a park position and enable retract so it will not spew half a ton of molten filament onto the print, destroying it completely?
i have lost a few good prints by the head burning a hole into the print on pause?
ryan.lutz last edited by
Use Custom G-Code, specifically Pause G-Code: http://wiki.mattercontrol.com/Settings/Printer/Cus...
You'll have to write a line or two of G-Code to get the printer to go where you want, but that will be the best way to accomplish what you're asking about.
Here's a link to a good reference on G-Code: http://reprap.org/wiki/G-code