Kossel Mini prints off the bed!

  • I have no idea what I have done! I have been printing for months using Mattercontrol with excellent results. Now my Kossel Mini - bed levels, warms up and then shoots off the bed between the Y and Z towers. An emergency reset stops it being silly. A test print with Cura is fine. I haven't the foggiest how to stop it doing this. Any ideas?

  • Solved it!

    I needed to set :

    Print Area, Print Centre - 0,0 It was set - 100 100

    General, Centre Print - OFF It was set - ON

    Now prints in the centre of the bed.

Log in to reply

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.