Dynamic Speed and Extrusion
-
In an effort to reduce the amount of time to do larger prints, I was trying to determine if there are currently any settings within the MatterControl 1.7 software that allow for a dynamic speed and extrusion rate based on the rate of angle change of the line being created on each layer?
i.e. for a line segment
straight - 100/1.1 (speed/extrusion)
slight angle - 80/1.05 (speed/extrusion)
sharp angle - 40/1 (speed/extrusion)
-
@jbrady21 MatterControl does not have this type of functionality. If this is a capability that you desire, then feel free to submit a functionality request to the MatterControl Github site.