Dynamic Speed and Extrusion

  • In an effort to reduce the amount of time to do larger prints, I was trying to determine if there are currently any settings within the MatterControl 1.7 software that allow for a dynamic speed and extrusion rate based on the rate of angle change of the line being created on each layer?

    i.e. for a line segment

    straight - 100/1.1 (speed/extrusion)
    slight angle - 80/1.05 (speed/extrusion)
    sharp angle - 40/1 (speed/extrusion)

  • MatterHackers

    @jbrady21 MatterControl does not have this type of functionality. If this is a capability that you desire, then feel free to submit a functionality request to the MatterControl Github site.

Log in to reply

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.