Duet Maestro Extruder Set up



  • Hello, i'm swapping out the extruder on my current(m3d Promega) with the bmg x2. Doing the actual swap is fine, but i'm not very well versed on the firmware portion of it. I've seen many articles on how to tune/calibrate an extruder, but not to start new with the esteps of the new one. Any help is greatly appreciated.


  • MatterHackers

    Setting the E-Steps is really not all that hard, I am not sure what the firmware is for your printer but, in the most basic sense, all you would need to do is open up the firmware and edit the standard E-Steps from what is loaded to 415.

    Can you provide some more information on the printer and its firmware?


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.