robo 3 1 plus stops printing in same spot everytime



  • Printer starts off fine, but during printing it always stops in the middle of the bed after a few layers into printing. Help needed in figuring this out.


  • MatterHackers

    Hey @humper0891

    Is this stoppage always in the same spot or is it in roughly the same area? This is a very important distinction as if it is the exact same spot that would point towards the G-code but if it is a rough area then that may be hardware related in some way.

    This can be solved in a few different ways but it is important to know which is happening. Do you mind dropping us a picture or two of the failed prints so I can better understand what we are looking at?

    Thanks!


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.