Wanhao Duplicator 4 (Dual Extruder) issue



  • Hi,

    I have inherited a Wanhao Duplicator 4 from a friend and trying to sort out the issues he never could...

    Looking around at printing software I came across some good information about using a WD4 with Mattercontrol so thought I would give it a go.

    Seems like a much better piece of printing software than ReplicatorG but has a few odd issues with my Printer.

    I have followed guides on how to best set up from scratch and what settings to use but still after setting up the second extruder my prints all seem to be pushed off centre from the bed.

    Either by default to the rear right hand corner or if I set what should be correct values for offsets, way off to the left of the bed.

    Can anyone suggest any solutions?

    Thanks in advance!



  • Thanks for your report. This is a known bug, and is on the list of issues to fix.

    At the moment, we don't have a work around solution to offer, unfortunately.


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.